Leveling - Fisher & Paykel AquaSmart WL4027P Instructions D'installation Et Guide D'utilisation

Installation instructions
US
10
CA
Leveling instructions
It is IMPORTANT to level the machine to ensure good spin performance and effective
detergent and fabric softener dispensing.
A spirit level is provided with your machine. Use this to level your machine, placing it bottom
side down in the locations specified below (ensure the surfaces are clean). The machine is
level when the bubble sits in the center, within the two lines.
Your washer is equipped with self-locking feet to ensure they do not move once you have
leveled your machine. To adjust the feet, tip the washer back or forward to locate the foot you
wish to adjust, pull down gently and then twist to move it up or down to the required level.
Repeat if necessary.
Important!
After leveling, the corners of the washer
should be clear of the floor (by at least
2/5" (10 mm) and the machine must not rock
in any direction.
If not already installed, fit the rubber inserts
1
into all 4 feet on the base of the machine.
Extend all 4 feet by three full turns before
2
moving the machine to its final position.
Move the machine to its final position using
3
the top corners to manoeuvre the product
into place (do not push against the center
front of the machine). We recommend a
minimum clearance of ¾" (20 mm) each
side and 2" (50 mm) at the rear of the
machine.
With the lid closed, place the spirit level at
4
the center back of the lid (near the control
panel). If not level, pull the machine out
and adjust the rear feet until the machine is
level side to side when in position.
Open the lid. Place spirit level on the flat
5
surface on the left side, inline with the
center of the basket. If necessary, adjust the
front left foot until the machine is level.
Adjustable feet
Rubber insert
Fig.6 Leveling – Step 1 & 2
Spirit level
Fig.7 Leveling – Step 4
Spirit level
Fig.8 Leveling – Step 5