Laminating The Humeral Section - Ottobock 12K41 Instructions D'utilisation

Laminating the humeral section
6 Service
Since all moving parts are subject to some wear and tear,
Ottobock recommends yearly service check-ups by your
prosthetist. During the service visit, the entire ErgoArm will
be inspected and any necessary adjustments or lubrication
will be made. Worn-out parts will be exchanged if necessary.
7 Liability
Otto Bock Healthcare Products GmbH, hereafter referred to
as manufacturer, assumes liability only if the user complies
with the processing, operating and maintenance instructions
as well as the service intervals. The manufacturer explicitly
states that this product may only be used in combination
with components that were authorized by the manufacturer
(see instructions for use and catalogs). The manufacturer
does not assume liability for damage caused by component
combinations which it did not authorize.
The product may only be opened and repaired by authorized
Ottobock technicians.
8 Trademarks
All denotations within this accompanying document are
subject to the provisions of the respective applicable trade-
mark laws and the rights of the respective owners, with no
restrictions.
All brands, trade names or company names may be reg-
istered trademarks and are subject to the rights of the
respective owners.
Should trademarks in this accompanying document fail
to be explicitly identified as such, this does not justify the
conclusion that the denotation in question is free of third-
party rights.
9 CE Conformity
This product meets the requirements of the 93/42/EWG
guidelines for medical products. This product has been
classified as a class I product according to the classifica-
tion criteria outlined in appendix IX of the guidelines. The
declaration of conformity was therefore created by Otto-
bock with sole responsibility according to appendix VII of
the guidelines.
10 | Ottobock

Laminating the humeral section

Take out countersunk screw.
Remove the band clamp.
Remove the lamination ring.
Lubricate the edge of the lamination protection cover as
well as the groove and inner edge of the lamination ring
with 633F11 silicone grease to prevent lamination resin
from entering.
12K41