V.ORLANDI GA25 Instructions De Montage, D'utilisation Et D'entretien page 39

2)
Checking the vertical play of the coupling pin:
check that the vertical play of the coupling pin (3) does not exceed 2 mm.
The play has to be measured by pushing the tip of the pin upwards (push "S")
when the opening handle (13) is down. In case the play exceeds the limit,
replace immediately the lift lever (2) see chapter 5.3 REPLACEMENT OF THE
LIFT LEVER AND THE LIFT LEVER SPRING page 19/24, chapter 7 DISPOSAL page
22/24;
3)
Checking the play of the opening handle:
Check that the free movement of the opening handle (13) is not over 10° as
shown in the figure. In case the limit is exceeded replace immediately the
opening handle (13) and the lift lever (2), see chapter 5.3 REPLACEMENT OF
THE LIFT LEVER AND OF THE LIFT LEVER SPRING page 19/24, chapter 7
DISPOSAL page 22/24;
4)
Lubrication:
Grease the drawbar coupling through the grease nipple (12). Always grease
the mechanism with the coupling pin (3) raised (see point 1 of the chapter
3.1 COUPLING UP page 09/24) in order to avoid over grease.
N
Do not over grease. Too much grease can hinder good functioning of
O
the mechanism;
T
E
DRAWBAR COUPLING GA25
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
1
3
Ø 22 min.
2 max.
"S" "S"
PAG.
15/24
CHAP . 4
REV. A