Yamaha VS-10 Mode D'emploi page 16

CONNECTIONS
Connecting the Control Center to the Subwoofer
Although the VS-10 alone can be used to reproduce rich and natural sounding audio, the additional use of a subwoofer allows
you to enjoy powerful bass tones.
Connecting the YAMAHA subwoofer, center speaker and rear speakers NX-SW10 (sold separately) can not only increase
bass sensitivity but improve the surround effect.
Control center
VIDEO SIGNAL
MONITOR
OUT
DIGITAL 1 VIDEO 1 TV
(V/PCM)
INPUT
When connecting your subwoofer, connect
the input terminal on the subwoofer to the
SUBWOOFER OUT terminal on the control
center using a commercially available audio
connection cord (1 pin).
Note
• When the power of the control center is turned off, that of the YAMAHA subwoofer SW-VS10 is also turned off accordingly.
y
• For details regarding connections, please refer to the instruction manuals for your subwoofer or the owner's manual for the YAMAHA
subwoofer, center speaker and rear speakers NX-SW10 (sold separately).
Connecting the AC Power Supply Cord
Control center
MAINS
14
+ – – +
DO NOT CONNECT THIS UNIT TO MARK
SPEAKERS OTHER THAN NX-VS10M
MAIN SPEAKERS
SYSTEM
OUT
CONNECTOR
SUBWOOFER
To AC outlet
To SYSTEM
CONNECTOR
terminal
System connector cable
supplied with the
YAMAHA NX-SW10
To SYSTEM
CONNECTOR terminal
Match the mark on the
plug with the mark on
the terminal and insert.
Once all connections have been made, check them one more
time. Finally, insert the plug of the power supply cord for
the control center into an AC outlet. Disconnect the power
supply cord if you will not use the unit for an extended
period.
YAMAHA subwoofer, center speaker and
rear speakers NX-SW10 (sold separately)