Using A Wireless System For Ipod - Yamaha R-S700 Mode D'emploi

PLAYING BACK TUNES FROM YOUR iPhone/iPod/Bluetooth™ COMPONENT

Using a Wireless System for iPod

By connecting a Wireless System for iPod to this unit, you
can play songs on your iPhone/iPod and listen to them
using a wireless connection.
y
You can use the remote control to control the iPhone/iPod. For
more information, see page 27.
Note
When playing an iPhone/iPod using a Wireless System for iPod,
playback information is not displayed on the front panel display.
YID-W10
transmitter
■ Establishing a wireless connection
Once the iPhone/iPod is connected to the YID-W10
transmitter and playback begins, it takes about 5 seconds
for audio to be heard. During this time the wireless
connection between the YID-W10 transmitter and
receiver is established.
The status of the wireless connection between the YID-
W10 transmitter and receiver is indicated by the
respective indicator.
YID-W10
Status of
transmitter
Connection
indicator
No connection Off
Confirming Green, flashing
connection
Connected Green, lit
28
En
■ Controlling this unit with your iPhone/
• When playback begins on an iPhone/iPod that is
• In the following situations, the wireless connection
YID-W10 receiver
y
These features can be disabled by setting "Interlock" to "OFF" in
the Option menu (see page 33).
• Adjusting the volume on the iPhone/iPod also adjusts
YID-W10
y
receiver
• When this unit is turned on or is in standby mode, your iPhone/
indicator
Off
Blue, flashing
• Refer to the operating instructions of the YID-W10 for more
Blue, lit
Note
When the iPhone/iPod is used in Zone 2, these features are not
available.
iPod
connected to a YID-W10 transmitter, and if the
YID-W10 transmitter is within range of the YID-W10
receiver, this unit performs as follows:
– If this unit is already turned on when playback
begins: The input source switches to DOCK.
– If this unit is in standby mode when playback
begins: This unit turns on and the input source
switches to DOCK.
between the transmitter and receiver is disconnected.
After 30 seconds this unit automatically enters standby
mode.
– The iPhone/iPod is not operated for about 30–120
seconds after the playback is paused.
– The sleep timer of the iPhone/iPod is activated.
– The iPhone/iPod is disconnected from the
YID-W10 transmitter.
– The iPhone/iPod battery level decreases to a level
where it cannot provide enough power to the
YID-W10 transmitter.
– The YID-W10 transmitter is moved outside of the
wireless communication range of the YID-W10
receiver.
– Communication between the YID-W10 transmitter
and receiver becomes disrupted due to interference
from other wireless LAN devices, cordless
telephones, microwave ovens, etc.
the volume of this unit. The iPhone/iPod can increase
the volume to up to 0 dB (or the value set for the
"MaxVol" setting in the Option menu). To further
increase the volume, adjust the volume using this unit's
VOLUME control or the remote control.
iPod can be charged automatically if the YID-W10 transmitter
connected to your iPhone/iPod is stationed in the YID-W10
receiver. The MAIN ZONE indicator remains brightly lit when
an iPhone/iPod is being charged.
information.