Infrared Remote Control - Cameo CLMPARCOB1 Manuel D'utilisation

INFRARED REMOTE CONTROL:

In order to control the MultiPAR lighting system using the infrared remote control, set the MultiPAR
lighting system in the IR ACTIVE "ON" mode, as described in paragraph "IR ACTIVE".
Functions of the control buttons on the IR remote control:
Bl (Blackout)
If you press this button when the lighting system is in operation, then all the lights and both Schuko power
outlets POWER OUT 1 and POWER OUT 2 will be switched off. Pressing the BL button once more activates the
previously selected mode again.
SP (Speed)
4-level speed setting for programmes Pr1 - Pr4 and D1 - D4.
Level 1 allows the colour change sequence to run slowly, pressing it again activates Level 2 at a faster sequence
of colour change, followed by Level 3 and 4.
(Brightness)
5-Level brightness setting for all programmes and static colour mixing. The various levels of brightness can be
activated by pressing this button repeatedly.
FL (Flash / stroboscope)
4-Level speed setting for the stroboscope effect. Level 1 deactivates the stroboscope effect, Level 2 represents
low, Level 3 medium, and Level 4 the fastest flash rate. The stroboscope effect can be combined with the colour
mixing mode and all colour change programs. The Schuko power outlet sockets in the multi-PAR system remain
unaffected by the stroboscope effect.
R / G / B / W (Red, Green, Blue, White)
These 4 buttons can be used to create individual colour combinations. The 4 levels of brightness can be activated
by repeated pressing of the respective colour button, whereby at Level 1 the LEDs are switched off. If you press
"W", the primary colours red, green and blue are automatically mixed together in equal proportions. The result is
white light.
For example: If you set red and green to their respective highest level and blue and white to their lowest, i.e., off,
the result will be a bright yellow colour mix.
Pr1 - Pr4
Colour change programs with various colour patterns. The colour change occurs abruptly. The speed at which the
colours change can be set using the "SP" (Speed) button.
D1 - D4
Colour change programs with various colour patterns. The colours blend into each other. The speed at which the
colours change can be set using the "SP" (Speed) button.
24