Troubleshooting - Fisher & Paykel DCS RF24DE3 Instructions D'installation, D'utilisation Et D'entretien

US
CA
Before You Call for Service
If the appliance appears to be malfunctioning, read through
this manual first. If the problem persists, check the trouble-
shooting guide below. Locate the problem in the guide and
refer to the cause and its remedy before calling for service.
The problem may be something very simple that can be
solved without a service call. However, it may be required
to contact your dealer or a qualified service technician.
Problem
Appliance not cold enough
(See "Adjusting the tempera-
ture" on page 10)
Appliance too cold
(See "Adjusting the Tempera-
ture" on page 10)
No interior light.
Light will not go out when
drawer is closed
Noise or Vibration
Appliance will not run.

TROUBLESHOOTING

Possible Cause
• Control set too warm
• Content temperature not stabilized.
• Excessive usage or prolonged drawer
openings.
• Airflow to front grille blocked.
• Drawer gasket not sealing properly.
• Control set too cold
• Drawer gasket not sealing properly.
• Failed LED light assembly or light switch. •
• Drawer not activating light switch.
• Failed light switch
• Appliance not level
• Fan hitting tube obstruction.
• Appliance turned off
• Power cord not plugged in.
• No power at outlet.
!
Electrocution Hazard
• Never attempt to repair or perform maintenance on
the appliance until the main electrical power has been
disconnected. Turning the appliance control "OFF"
does not remove electrical power from the units wiring.
• Replace all parts and panels before operating.
• Adjust temperature colder. Allow 24
hours for temperature to stabilize.
• Allow temperature to stabilize for at
least 24 hours.
• Airflow must not be obstructed to front
grille. See "clearances" on page 4.
• Adjust or replace drawer gasket.
• Adjust temperature warmer.
Allow 24 hours for temperature to stabilize.
• Adjust or replace drawer gasket.
Contact a qualified service technician.
• Appliance not level, level appliance,
(See page 4, "leveling legs")
• Contact a qualified service technician.
• Level appliance, see "Leveling Legs" on
page 4.
• Contact a qualified service technician.
• Turn appliance on. See "Starting your
appliance" on page 10.
• Plug in power cord.
• Check house circuit.
14
WARNING
Remedy