Wiring Work; Wiring - Tabuchi Electric EneTelus EHW-S55P3B-PNUS Manuel D'installation

3
Attatch the remote control panel to the bracket.
●
Be sure not to pinch the cable between the
bracket and the remote control panel.
●
Press the remote control panel against the
bracket and slide it downward.
Confirm the remote control panel is securely
clipped to the bracket.
Wiring Installation
●
Wear protective gloves and use electrically insulated tools when installing electrical wiring work.
Working without protection may result in electric shock or injury.
●
Be sure to observe all of the following precautions when installing electrical wiring work.
Failure to do so may result in electric shock or equipment failure.
MANDARTORY ・Keep all switches in the OFF position until wiring work is completed. This includes the solar panel
switch on the outside of the inverter, the grid-tied breaker in the home breaker box, the breakers in the back-up
breaker box, and the switch inside the storage battery unit.
・Do not damage the wire sheathing.
●
Use wiring of the recommended wire gauge (Page 5) and connect wiring to the terminal blocks using
the specified crimp terminal.
MANDARTORY
Inadequate wiring materials and connections may result in fire or equipment failure.
To measure insulation resistance
Measuring insulation resistance
while the wires are connected will
damage the internal circuits. Do
n o t c o n d u c t t h e i n s u l a t i o n
resistance testing on the inverter
terminals.
Be sure to disconnect the electric
wire from the terminal before
measuring insulation resistance.
Also, be sure to disconnect all
electric wiring before measuring
insulation resistance of the
storage batteries or solar panels.
WARNING
CAUTION
Do not measure resistance
between the terminals.
Inverter
Insulation Tester
Storage Battery Unit
Remote Control Panel
Measure resistance
between the wires.
G
G
Insulation Tester
Storage Battery Unit
Bracket
Inverter
G
G
15