ECOFOREST VAP 30 Manuel D'installation Et Maintenance page 44


Bronze bushing.

Compression spring (replace every 2 years).
5.14. Cleaning of the heat exchanger. (Multipurpose lithium grease, NLGI: 2, 3 for forks). (8 lubrication points).
To access the lubrication points in the heat exchanger cleaning system, you must first remove the
exchanger's front and top rear lining. Lubricate between: the bushings and the shaft, the fork connection
shaft, the plain bearings and the shaft. In addition to the points shown in Drawing 25, there are 2 more
bushings (located in the machine's front panel) that need lubrication.

Bronze bushing.

Fork.

Plain bearing.
5.15. Ash removal. (Multipurpose lithium grease, NLGI: 2. Grease gun required). (5 lubrication points).
Disassemble the right-hand side and bottom rear lining. Apply, with the help of a gun, grease between the
shaft and the bearings (see Drawings 26 and 27), and the chains and the sprockets (Drawing 28).

Bearing.

Bearing.
43
Drawing 24
Drawing 25
Drawing 26
Drawing 27