ECOFOREST VAP 30 Manuel D'installation Et Maintenance page 39

5. CLEANING AND MAINTENANCE.
To ensure the correct operation of your boiler, the following Cleaning and maintenance operations are
necessary at the indicated frequency. The boiler must always be cold.
The deterioration of the boiler parts by a lack of cleaning involves the loss of the two-year warranty offered
by ECOFOREST (see warranty section).
MAINTENANCE AT END OF SEASON OR AFTER AN ALARM MESSAGE (A036/A037).
This is necessary to ensure correct operation and maintain the stove's life duration. When winter ends,
contact your provider (if he did not contact you) and meet to carry out this maintenance; the following shall be done
(the stove must always be disconnected from power):

Screw driver / allen wrench. 3, 4 and 5mm

Screw driver / Torx wrench. T20

Spanner.

Cable / cord / wire.

Cleaning brush

Vacuum cleaning

Exchanger cleaner.
5.1. Ash box.
Empty the ash box at the end of the season or after an alarm message (see User manual). To remove the ash
box, you have to first take out the through bolt. Please check the capacity of the ash box in section 10
(Technical characteristics).
Once the ash box has been emptied, put it back into place.
Warning: the ash extraction system won't work as long as the ash box is not in its intended position or the
cover is open.

Ash box

Four-point knob (box cover opening).

Through bolt.
Tools needed for cleaning and maintenance.
7, 10 and 15mm
L > 800mm
38
Drawing 15
Drawing 16