Fan Speed Button; Plasmacluster On/Off Button; Lights On/Off Button; Water Supply Indicator Light - Sharp KC-C70E Manuel D'utilisation

OPERATION

Plasmacluster ON/OFF Button

Press the Plasmacluster ON/OFF Button to turn Plasmaclus-
ter Ion Mode ON and OFF. A green light will indicate that the
Plasmacluster Ion Mode in ON.

LIGHTS ON/OFF Button

Press this button to turn Front Panel monitor lights ON and
OFF.

WATER SUPPLY INDICATOR LIGHT

When the Water Tank is empty, the Water Supply Indicator
Light will flash to indicate that the Water Tank should be refilled.
Please note the light will not flash even when the Water
Tank is empty during the Clean Air Mode and the Clean ION
SHOWER Mode.
Sound indicator setting for water supply.
In addition to the Indicator Light, the unit can be set to signal
with an audible beep when the Water Tank is empty. With the
unit OFF, press the Lights ON/OFF button for 3 seconds to turn
the audible signal ON.
Cancellation
To cancel the audible signal, with the unit OFF, press the Lights
ON/OFF button again more than 3 seconds.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to 'low" if the DUST MONITOR and ODOUR MONITOR is constantly red to reduce
sensitivity, and set to 'high' if the DUST MONITOR and ODOUR MONITOR is constantly
green to increase sensitivity.
1
With the unit OFF, press the Fan Speed Button for 3 seconds.
The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The
factory setting is Standard, indicated by the MED light.
2
Press the Fan Speed Button to set
the desired sensor sensitivity.
Refer to the diagram on the right to select the
desired sensor sensitivity level.
3
Press the Power OFF Button.
Note that if the Power OFF Button is not pushed
within 8 seconds of adjusting sensor sensitiv-
ity, the setting will be saved automatically. The
sensor sensitivity setting will be saved even if
the unit is unplugged.
Fan Speed
Indicator Light
E-10
Sensor Detection
sensitivity
High
Standard
Low