Plasmacluster On/Off Button; Adjustment Of Sensor Detection Sensitivity - Sharp FU-W28E Manuel D'utilisation

Fan Speed Button

Plasmacluster ON/OFF Button

POWER ON/OFF Button
CLEAN - SIGN Light
The colour changes according to the air condition.
ABOUT THE CLEAN-SIGN
• The condition of the CLEAN-SIGN depends on the room air condition detected by the Odour Sensor
when the plug is inserted into the wall outlet.
• It is possible to have a green CLEAN SIGN if there are impurities in the are when the product is first turned on.
After a while, however, the base impurit rate will be adjusted to detect room air condition correctly.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to "low" if CLEAN-SIGN Light constantly red to reduce sensitivity, and set to "high"
if CLEAN-SIGN Light is constantly green to increase sensitivity.
1
With the unit OFF, press the Fan Speed Button for 3 seconds.
The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The
factory setting is Standard, indicated by the MED light.
2
Press the Fan Speed Button to set the
desired sensor sensitivity.
Refer to the diagram on the right to select the
desired sensor sensitivity level.
3
Press the Power ON/OFF Button.
Note that if the Power ON/OFF Button is not
pushed within 8 seconds of adjusting sen-
sor sensitivity, the setting will be saved auto-
matically. The sensor sensitivity setting will be
saved even if the unit is unplugged.
Clean
Green
Plasmacluster ON/OFF Button
Press the Plasmacluster ON/OFF Button to turn Plasmacluster
Ion Mode ON and OFF.
When Plasmacluster is ON, both the Indicator Light and Plas-
macluster Indicator Light will turn on.(blue)
LIGHTS ON/OFF Button
(Please press the Plasmacluster ON/OFF Button for 3 seconds.)
Switches the Plasmacluster Indicator Light and CLEAN-SIGN
Light either ON or OFF.
E-9
Slightly Impure Very Impure
Orange Red
Fan Speed Sensor Detection
Indicator Light
sensitivity
High
Standard
Low