The Input Assign Menu - Pioneer VSX-415 Mode D'emploi

07 The System Setup menu
Tip
• For best surround sound, make sure the
surround back speakers are the same
distance from the listening position.

The Input Assign menu

You only need to make settings in the Input
Assign menu if you didn't hook up your digital
equipment according to the default settings for
the digital inputs, or if you have connected
equipment using component video cables.
1 Select 'IN ASSIG.' from the System Setup
menu.
See Making receiver settings from the System
Setup menu on page 41 for more on this.
2 Use (cursor left/right) to select the
setting you want to adjust then press ENTER .
• DIG. IN – See Assigning the digital inputs
below.
• COMP. IN – See Assigning the component
video inputs below.
Assigning the digital inputs
• Default settings:
COAX 1 (coaxial) – DVD
COAX 2 (coaxial) – CD
OPT 1 (optical) – TV
You only need to do this if you didn't hook up
your digital equipment according to the default
settings for the digital inputs (see above). This
setting tells the receiver what digital
equipment is hooked up to which terminal so
the buttons on the remote correspond to what
you have hooked up.
1 Select DIG. IN from the IN ASSIG. menu.
2 Select the number of the digital input to
which you've connected your digital
component.
The numbers correspond with the numbers
beside the inputs on the back of the receiver.
44
En
3 Select the component that corresponds
with the one you connected to that input.
Select DVD, TV, CD, CDR, DVR or OFF.
• Use the (cursor up/down) buttons
and ENTER to do this.
• If you assign a digital input to a certain
function (for example, DVD) then any
digital inputs previously assigned to that
function will automatically be switched off.
4 When you're finished, press RETURN.
Assigning the component video inputs
• Default settings:
COMP 1 – DVD
COMP 2 – TV
If you didn't make component video
connections according to the defaults above,
you must assign the numbered input to the
component you've connected (or else you may
see the video signal of a different component).
For more on this, see Using the component
video jacks on page 16.
1 Select COMP. IN from the IN ASSIG. menu.
2 Select the number of the component
video input to which you've connected your
video component.
Select between DVD, TV, DVR or OFF.
• The numbers match the numbers beside
the inputs on the back of the receiver.
3 Select the component that corresponds
with the one you connected to that input.
• Use the (cursor up/down) buttons
and ENTER to do this.
• Make sure you have connected the audio
from the component to the corresponding
inputs on the rear of the receiver.
• If you connect any source component to
the receiver using a component video
input, you should also have your TV
connected to this receiver's COMPONENT
VIDEO MONITOR OUT jacks.
4 When you're finished, press RETURN.