INFOSEC UPS SYSTEM E6 LCD 1000 RT Manuel Utilisateur page 47

3. To release the UPS lock, please proceed the followings:
a. Check those error messages recorded
b. Check to see Chapter 6.2 to trouble shoot the problem of the UPS;
otherwise, consult your local distributor for service.
c. Press
d. Turn off the Breaker of the Utility Input.
e. The UPS lock problem is solved now.
Shut Off
1. Press key pad for about 5-10 seconds, the Inverter output will be turned off,
the UPS will stop power supply to the outlets and the LCD screen shows as drawing
B.
2. Turn off the input of the UPS.
3. The UPS is turned off completely.
Status & Alarm Buzzer
The following table helps to define some of the common UPS statuses with respect to
their buzzer beep descriptions.
Status Definitions
UPS faulty, Inverter shutdown. All
functions inhabited.
UPS faulty, loads continue to be
supplied via Inverter or Bypass.
Battery mode
Battery low
Confirm/RS232 port receiving
Service mode ok
UPS initial starts up with self-test
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 06 11 AA 68 203 03
key pad for 5 seconds and buzzer will sound twice.
Long Continuous Beep
Single successive beep with ~ 2 sec interval
Single short successive beep with ~1 sec interval
Very quick and short successive beep
2 quick & short beeps
1 quick & short beep
2 successive quick & short beeps, repeating per
~2 sec interval.
Buzzer Beep Descriptions
46