INFOSEC UPS SYSTEM E6 LCD 1000 RT Manuel Utilisateur page 37

Programmable outlet setting
The UPS is equipped with 2 programmable outlets
for use to supply to less critical loads. These outlets
can be disabled to shed the less critical loads during
back-up modes or overload conditions to maintain
quality power supply to the more critical loads
connected to the UPS.
Click on the "Programmable outlet setting" bar to
enter to the setting screen as shown below.
1. Outlet Turn On After Turn on UPS –
time to automatically enable this outlet within
the specified time when the UPS is powered
on. If "0" sec is selected, the outlet will be
enabled once the UPS is powered on
2. Outlet Turn Off After AC Failure –
outlet within the specified time after utility outage to shed the less critical loads to
provide longer battery back-up time for the other more critical loads connected to
the UPS.
3. Outlet Turn On After AC Recovered –
outlet within the specified time after the utility is restored.
4. Outlet Turn Off When Battery Lower than -
disable the outlet at the specified remaining battery power capacity(%) during
battery mode to shed the less critical loads to prolong battery back-up time for the
other more critical loads connected to the UPS.
5. Outlet Turn Off When Overload –
outlet during overload condition (bypass mode) to possibly allow the more critical
loads:
a) To be continually supplied via Bypass without shut down
6. You have to select the "Setting" menu to configure new parameters. The
calibration is confirmed successfully after the UPS beeps twice. Turn off the UPS
and unplug input power cord from AC Power Utility receptacle to shut down whole
unit without internal power supply existing, after setting is complete. 3 seconds
later reconnect input power cord into AC Power Utility receptacle and turn on the
UPS, referring to the section 4.4 Operation. The UPS will perform in new settings.
7. Manual Control Switch – Click "On" or "Off" to manually enabled or disabled the
programmable outlets, overriding all previous settings
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 06 11 AA 68 203 03
select the
.
select this option to automatically disable the
select this option to automatically enable the
select this option to automatically
select this option to automatically disable the
.
36