Others - Pioneer MCS-838 Mode D'emploi

88 Troubleshooting
En

Others

Problem
Power does not
turned on.
The player's power turns
off automatically.
The player's power turns
on automatically.
Cannot be operated with
the remote control.
Settings I have made have
been cleared.
USB (external storage)
device does not work with
this player properly.
Cannot record to a USB
device.
Display window is dark.
9
"OC ERROR" is displayed
on the unit's display
window.
Check
Is the power cord properly
connected?
Is Auto Power Off set to
10 min/20 min/30 min?
Is Control set to On?
Is Control set to On?
Are you operating the remote
control from a point too far
away from the player?
Are the batteries dead?
Have you disconnected the
power cord while the player's
power was on?
Has there been a power
failure?
Is the USB device properly
connected?
Is the USB device connected
via an extension cable?
Is the external storage device
connected to the USB port via
a memory card reader or USB
hub?
Does the external storage
device contain multiple
partitions?
Is the external storage device
write-protected?
Is the external storage device's
file system FAT16, FAT32 or
NTFS?
A USB device is not connected
to the USB port on the rear of
the unit.
There is not enough free
memory in the USB device.
The USB device format is not
set correctly.
Remedy
Plug the power cord securely into the power outlet.
Unplug the power cord, wait several seconds, then plug the power
cord back in.
If Auto Power Off is set to 10 min/20 min/30 min, the player's power
automatically turns off if no operation is performed for the set amount
of time (page 76).
The player's power may turn off together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn off when the TV's power is turned off, set Control to Off
(page 74).
The player's power may turn on together with the power of the TV
connected to the HDMI OUT terminal. If you do not want the player's
power to turn on when the TV's power is turned on, set Control to Off
(page 74).
Operate from within 7 m of the remote control sensor.
Replace the batteries (page 10).
Always press STANDBY/ON on the player's front panel or
ON
the player's front panel display and wait for more than 10 seconds before
disconnecting the power cord. Be particularly careful when the power
cord is connected to the AC outlet on another device because the player
turns off in conjunction with the device.
Turn the player's power off, then turn the power back on.
Turn the player's power off, then reconnect the external storage device
(page 44).
Do not use an extension cable. The player may not work properly with it.
External storage device may not work if connected to the USB port via a
memory card reader or USB hub.
External storage devices may not be recognized if they contain multiple
partitions.
Turn the player's power off, then disable the write-protection.
Only external storage devices with a FAT16, FAT32 or NTFS file system
can be used.
Some external storage devices may not operate.
You cannot use the USB port on the front of the unit to record.
Please check to make sure that there is enough free memory in the
USB device.
Please set the USB device to the correct format.
Press the DIMMER on the remote and select the desired display
brightness.
Unplug the unit and contact the Pioneer Customer Support Center.
STANDBY/