OHAUS VE Serie Manuel D'instructions page 15

VE Series Floor Scale
VE SERIES FLOOR SCALE, INSTALLATION OF OPTIONAL FOOT PLATES AND RAMPS
Plates are required for certifiable installations. Installation of each Ramp also requires the installation of one set of Foot Plates.
Foot Plates are available separately and are included with the Ramp accessory kit. Refer to Figure 3 for mounting of the Foot
Plates and Ramps. Installation of Floor Plates and Ramps must be done before final placement of the Floor Scale.
LEGEND: 1.Foot Plate, 2. Bolt, 3. Spring Washer, 4. Washer, 5. Expanding Bolt, 6. washer, 7. Nut
Notes: 1. Expanding bolts require 12.5mm diameter holes drilled 60mm deep into the floor surface.
2. Foot Plate center to center dimensions W and L are shown in Table 4.
3. The Floor Scale must be positioned so that the load cell feet rest within the large holes of the Foot Plates.
4. Ensure that a free air gap exists between the sides of the Floor Scale and the edges of the Ramps.
MODELS
Ramp for VE1500S/SW
Ramp for VE1500R/RW &
VE3000R/RW
Ramp for VE1500L/LW &
VE3000L/LW
Figure 3. Optional Foot Plate and Ramp Installation
TABLE 6. DIMENSIONS FOR FLOOR PLATE AND RAMP INSTALLATION
RAMP
A
1000
1250
1500
DIMENSIONS (mm)
B
670
670 1140
670 1390
FOOT PLATE CENTERS
W
890
EN-7
L
890
1140
1390