Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4
INSTALLATION OF INDOOR UNIT
Installation Place
• A place which provides the spaces around the indoor
unit as shown in the above diagram.
• A place where there is no obstacle near the air inlet
and outlet.
• A place that allows easy installation of the piping to
the outdoor unit.
• A place which allows the Front panel to be opened.
CAUTION
• Direct sunlight or fluorescent light to the indoor
unit's wireless receiver should be avoided.
• The microprocessor in the indoor unit should not
be too close to RF noise sources.
(For details, see the owner's manual.)
Remote controller
• A place where there are no obstacles such as a
curtain that may block the signal from the indoor unit.
• Do not install the remote controller in a place exposed
to direct sunlight or close to a heating source, such as
a stove.
• Keep the remote controller at least 1 m apart from the
nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
• The location of the remote controller should be
determined as shown below.
Remote controller usage
• Under Ceiling Installation
Ceiling
Wall
Remote controller
Reception range
• Console Installation
7 m
Remote controller
Reception
Wall
range
Floor
NOTICE
The Paper pattern is inside the package box cover.
Do not bend and dispose of it before installing.
Reception
Remote
range
controller
Reception
Remote
range
controller
* Axial distance
Before Installation
Remove the Air inlet grille
1. Open the Air inlet grille by both hands.
2. Loosen three screws for fixing the Panel arm. Do not
remove the screws at this time.
1
3. First, move the Air inlet grille upward, then turn it
backwards.
4. Remove the Grille stopper from the axis of the Front
panel. After that, remove the Air inlet grille.
5. Remove the Panel arms from the Front panel.
Grille stopper
After Installation
Install the Air inlet grille
1. Insert the three Panel Arms on the Air inlet grille and
fix each securely by screws.
• The screws that fixed with Panel Arms must not be
loose.
6
1
2
2
Screw
3
Panel arm
3
5
Panel arm
CAUTION
Panel arm
Publicité
Table des Matières
