Warnings And Errors In The System - Airzone FLEXA 3.0 Manuel D'utilisation

• Standard: Mode by default. The system automatically regulates the speed
based on the number of zones.
• Silence: The speed of the system is lower than in standard mode to reduce
the noise.
• Minimum: The system operates at minimum speed, irrespective of the
number of zones.
Lite settings: You can use this parameter to define base set-point temperature
for zones with Airzone Lite. Besides, you can also configure your wired Airzone
Lite cable to act as wireless (the LED light will switch off after a few seconds).
Note: To access this parameter, you have to access any zone controlled by a Lite thermostat through the zone
navigation.

Warnings and errors in the system

Airzone Blueface thermostat displays all the system
warnings in your screensaver. Besides, if there is any
error, it will be displayed on the screensaver, on the
main screen and on "About errors", in user settings.
Warnings
Anti-freezing: It will be displayed in case of activation (see zone settings, page 11).
Window: This warning indicates the air conditioning of the zone has been suspended
due to open window. Only available if the window contact of the system is activated.
Battery. Low battery warning. You will know the zone the warning comes from by
pressing on the icon.
Incidents
The system has a mechanism to control all the incidents. If any message error is
displayed, please contact your installer.
Error 9: The system will open all the doors to allow the use of the air conditioning
from the AC unit controller. Once the incident is solved, the system will return to its
previous state.
Once the incident is solved, the error warning will disappear from the screen.
EN
12