Overview - Multilift Ii; Function Description - RK Rose+Krieger Multilift I Notice De Montage

Set-up and function

Function description

Motor cable/socket inlet
Fig. 5: Motor cable/socket inlet

3.1.2 Overview - Multilift II

Fig. 6: Overview of Multilift II
A Multilift II Standard/ESD/impact/clean
B Multilift II telescope/telescope ESD
1 Motor cable
2 Motor housing
3 Base plate
3.2 Function description
Multilift I/II
86
1 Motor cable
2 Socket inlet
On the Mono version (
out of the top of the motor housing.
On the Synchro version (
(Fig. 5/2) on the side of the motor housing for connecting a motor
cable.
4 External profile
5 Cover flap external profile
6 Internal profile
7 Cover flap middle profile
8 Middle profile
The Multilift I and II lifting columns are used for adjusting the height
of connecting constructions (e.g. table frames) and other similar
adjustment tasks.
The lifting columns are driven using external controllers. A hand
switch for positioning the lifting columns is connected to the
external controller.
Lifting column Multilift I/Multilift II
Ä page87) a motor cable (Fig. 5/1) runs
Ä page 87) there is a socket inlet
20.02.2019