After-Sales Service; Technical Data - Burda PEFRECTCLIME RELAX DARK IRC IP55 Notice D'installation Et D'utilisation

and IEC 60364-7 1988 Internationally, AS/
NZS 3000 for Australia) and according to
the UE 2015/1188 standards. Risk of fire!
• Only commission the device after it has
been fully installed.
• This heater comes with a pair of stainless
steel adjustable angle mounting brackets. The
adjustable angle enables the heater to be
installed on horizontal and inclined surfaces.
NOTE:
- After switching on the appliance for
the first time and following extended periods
on non-use, the appliance may expel a slight
odor for a short time. It will not affect the use
of the heater.
- To exclude unpleasant burnt odor,
it is recommended to keep the heater clean
preventing accumulation of dust on it
INSTALLATION:
In case of direct connection to the supply line,
a bipolar switch or a bipolar circuit breaker
with contact opening distance of at least
3mm must be fitted upstream from the supply
line. Contact an authorized service technician
if you are unsure if you have a switch or a
circuit breaker installed on the premises.
- Plug in the device in the socket of
main power, the heater starts heating.
- Unplug the device from the socket or
press the switch or the circuit break to power
off the device.
CLEANING:
• First, disconnect the equipment from the
power supply system!
• After the appliance has cooled down, wipe
off dust with a damp soft rag.
• During operation, it is necessary to period-
ically (once a year) check the electric cable
contacts and terminal connectors for good
tightening.
• Make sure all parts are dry before using
again.
• Do not use any abrasive or caustic clean-
ing agents!
• Never immerse the appliance in water!
Danger to life!

AFTER-SALES SERVICE:

• All repairs must be referred to authorised
personnel! Therefore, you should contact your
specialized dealer or the customer service.
• Important! Any tampering with the appli-
ance will invalidate the warranty.
• Repairs carried out improperly and by
unqualified persons may have serious conse-
quences for the user!

TECHNICAL DATA:

• Connection/fuse: 230/240 Volt (50/60
Hz) with 16 Amp
C (= slow-blowing fuse)
• Output: 2200 Watt = BRELD2200-3 und
2400 Watt = BRELD2200-1
• Guaranteed service life: up to 5000 hours
with average use
• Type of protection: IP55
• Weight: 7.8 kg
• Casing: Corrosion-resistance anodized
aluminium
• Cable: 1.90m 3-wire 1.5 mm², Schuko
plug
MAINTENANCE:
• To avoid risk of failures it is necessary
to operate the unit for a few hours every 6
months.
• If you have any question relevant your
appliance, call the local authorized distributor
or the nearest Service Centre. Every repairs
should be carried on by an authorized Ser-
vice Centre and also ask always for original
spare parts.
• Before cleaning, be sure the appliance is
disconnected from the power supply and al-
lowed to cool. Never immerse the appliance
in water or any other liquid.
GB