Skil PWRCORE 12 IW6744A-00 Guide D'utilisation page 14

Changing the Work Modes
When the tool is set in reverse rotation, the
•
work mode – a combination of rotation speed,
impact rate, and torque – can be changed to
allow a loosening force suitable to the work at
hand. Every time the mode button is pressed,
the mode will toggle between 4 work modes:
a. Low-Speed Mode - Indicator light above "1"
shines green.
b. Medium-Speed Mode - Indicator lights above
"1" and "2" shine green.
c. High-Speed Mode - Indicator lights above 1,
2, and 3 shine green.
d. Reverse control Mode - Indicator light
corresponding to "RM" shines green.
In reverse control mode, the tool loosens a bolt or nut at high-speed first. Once the nut or bolt
is completely loose, the tool will stop automatically to prevent the bolt or nut from falling out.
The reverse control mode is available only when the tool is set is reverse rotation. If the tool is
switched to forward rotation while in reverse control mode, the impact force and speed are the
same as the high-speed mode "3".
The modes can also be changed when the tool is set in forward rotation to allow a tightening
•
force suitable to the work at hand.
NOTICE: The work mode can be changed only when any mode-indicator light is shining and
the trigger switch is not depressed. The mode button is disabled when the motor is running.
The work mode will be stored in memory and reactivated the next time the tool is turned on or
when the direction of rotation has been changed. Reset the impact modes as desired.
When the trigger is squeezed slightly, the LED light button is pressed, or the mode button is
pressed, any of the four indicator lights will automatically shine green, to indicate the work
mode saved during the last use and will turn off approximately 60 seconds after the variable
speed trigger switch is released. It means that during approximately one minute after releas-
ing the switch trigger, the work mode can be changed.
Impact force mode
displayed
Low-Speed Mode
Medium-Speed
Mode
High-Speed Mode
Reverse Control
Mode
14
Maximum
Impact Rate
(IPM)
Tightening small
2000 diameter fasteners when
you need fine control.
Tightening fasteners
3200 when medium torque
and speed are desired.
Tightening when high
3400 torque and speed are
desired.
Loosening with auto
3400
stop function.
Fig. 6
1 2 3 RM
M
10 SECS
LOW
10 MINS
HIGH
1 2 3 RM
M
10 SECS
LOW
10 MINS
HIGH
1 2 3 RM
M
10 SECS
LOW
10 MINS
HIGH
1 2 3 RM
M
10 SECS
LOW
10 MINS
HIGH
Purpose
Light duty mechanical
repairs
Conducting mechanical
repairs.
Assembling steel frames.
Disassembling bolts/nuts.
Low-speed Mode
Medium-speed Mode
High-speed Mode
Reverse Control Mode
Example of application