Skil PWRCORE 12 IW6744A-00 Guide D'utilisation page 13

Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the variable
speed trigger switch.
The variable-speed trigger switch delivers high-
er speed with increased trigger pressure and
lower speed with decreased trigger pressure
(Fig. 4).
LED Light (Fig. 5)
Your tool is equipped with an LED light,
located on the head of the tool. This provides
addtional light without shadows on the surface
of the work piece for operation in lower-light
areas.
To turn on the LED light:
The LED light will automatically turn on with a
•
slight squeeze on the variable-speed trigger
switch before the tool starts running.
The LED light could be turned on manually
•
by pressing either the LED light button or the
mode button.
To adjust the LED light brightness:
Every time the LED light button is pressed, the brightness will toggle between Low
•
Brightness and High Brightness:
a. At Low Brightness, the LED light will turn off approximately 10 seconds after the variable-
speed trigger switch is released without pressing the LED light button or the mode button
again;
b. At High Brightness, the LED light will turn off approximately 600 seconds after the variable-
speed trigger switch is released without pressing the LED light button or the mode button
again.
NOTICE: The brightness setting of the LED light will not be stored in memory or reactivated
the next time the tool is turned on. The LED light will always illuminate at default, low
brightness when it is turned on again.
NOTICE: The brightness can be adjusted only when the motor is not running. The LED light
button is disabled when the motor is running.
When the tool and/or battery pack becomes overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack are overloaded, the LED light will flash rapidly.
Rest the tool for a while or place the tool and battery pack separately under air flow to cool.
The LED light will flash more slowly to indicate that the battery is at low-battery capacity.
Recharge the battery pack.
Fig. 4
Fig. 5
LED Light
Variable-Speed
Trigger Switch
LED Light Button
Mode Button
13