Skil PWRCORE 12 IW6744A-00 Guide D'utilisation page 12

Direction-of-Rotation (Forward/Center-Lock/Reverse) Selector
WARNING
injury.
Your tool is equipped with a direction-of-rotation selector, located above the variable-speed
trigger switch. This selector is used to change the direction of rotation of the bit and to lock the
variable-speed trigger in the "OFF" (center-lock) position (Fig. 3).
a. Position the direction-of-rotation selector to the far left of the tool for forward rotation to
tighten bolts and nuts.
b. Position the direction-of-rotation selector to the far right of the tool for reverse rotation to
loosen bolts and nuts.
c. Position the switch in the "OFF" (center-lock) position to help reduce the possibility of
accidental starting when the tool is not in use.
NOTICE: To prevent gear damage, always allow the impact wrench to come to a complete
stop before changing the direction of rotation.
NOTICE: The impact wrench will not run unless the direction-of-rotation selector is engaged
fully to the left or to the right.
Fig. 3
12
After tool use, lock the direction-of-rotation selector in the "OFF"
position (center-lock) to help prevent accidental starts and possible
Forward
Center-Lock Reverse