Cautions On Handling; Navigation System - Clarion NP400 Mode D'emploi Et Manuel D'installation

1. Even in the event that trouble arises, never open the case,
disassemble the unit, or lubricate the rotating parts.
. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to consult the dealer
or an experienced radio/TV technician for help.

2. CAUTIONS ON HANDLING

Navigation System

• To prevent discharge of the car battery, use this system
with the engine of the vehicle running as much as
possible.
• The housing of this unit may become hot because this
unit has a high-speed CPU. Be careful to handle the unit
during navigating or immediately after turning the power
off.
• Turn off the power of the vehicle when connecting or
disconnecting wires. Doing this while the power of the
vehicle is turned on, may cause a trouble or malfunction.
Note:
• When using this unit first time after purchasing, or not
used for long periods of time, it might take about 5 to 15
minutes until the current location is determined using
GPS. Moreover, even when using it often, it may take
about  to 3 minutes until the current location is
determined according to the GPS measuring situation.
4 NP400
All manuals and user guides at all-guides.com
INFORMATION FOR USERS:
CHANGES OR MODIFICATIONS TO THIS
PRODUCT NOT APPROVED BY THE
MANUFACTURER WILL VOID THE WARRANTY
AND WILL VIOLATE FCC APPROVAL
• When the route (path) cannot be calculated, move
desired destination to a nearby main road and perform
calculation again. It may be impossible to find a route
in case the car location is too close to the desired
destination.
• For vehicles equipped with an intelligent key, do
not bring the intelligent key close to the unit of the
navigation system. The navigation system may not
operate correctly.
• If an electrical equipment that generates a strong
electrical noise is used near this unit, the screen may
be disturbed and noise may be generated. In this case,
keep away such an electrical equipment or refrain
from using it.