PowerWalker VFI 1000RM LCD Manuel D'usage page 10

4-battery kit
Step 1: Remove adhesive tapes.
Tapes
EN
Step 3: Put assembled battery packs on
one side of plastic shells.
6-battery kit
Step 1: Remove adhesive tapes.
Tapes
Step 3: Put assembled battery packs on
one side of plastic shells.
Step 2: Connect all battery terminals by
following below chart.
Tapes
Step 4: Cover the other side of plastic shell as
below chart. Then, battery kit is assembly well.
Step 2: Connect all battery terminals by
following below chart.
Tapes
Step 4: Cover the other side of plastic shell as
below chart. Then, battery kit is assembly well.
9