Recommended Uses For Baier Diamond Dry-Cutting Discs; Handling Diamond Dry-Cutting Discs; Tools And Accessories; Disposal - Baier BDN 511 Traduction De La Version Originale Du Mode D'emploi

EN
7 Recommended uses for
BAIER diamond dry-cutting
discs
Coding colour of the diamond
Uses blue
Granite x
Concrete xx
Precast
concrete xxx
blocks
Sand-lime
x
blocks
Bricks
Poroton
Cellular
concrete
Plaster
xxx optimally suitable
xx well-suited
x suitable
8 Handling Diamond
Dry-cutting Discs
•
Always use and store diamond dry-cutting
discs in accordance with the manufacturer's
instructions.
•
Too soft diamond segments:
f Diamond dry-cutting discs wear too quickly
at very high removal rate.
Remedy: The material to be machined
requires diamond dry-cutting discs with a
harder bond.
•
Too hard diamond segments:
f The diamond grains become blunt and do
not break out of the bond. The diamond
dry-cutting discs no longer have any cutting
power.
Remedy: The material to be machined
requires diamond dry-cutting discs with a
softer bond.
•
In the event of loss in cutting power (recognis-
able by intensity of flying sparks) resharpen the
diamond dry-cutting discs by making several
cuts in abrasive material, e.g. sandstone or with
the BAIER professional whetstone
(ID No. 15453).
•
Work without applying pressure – the weight of
the machine is sufficient. Increased pressure
causes increased wear.
| 40 |
cutting discs
white yellow gold
xxx
xxx xx
x xx xx
xxx x xxx
xxx xxx
xxx xxx
xxx
xxx
•
Excessive cutting pressure can cause material
fatigue in the base metal and therefore the
formation of cracks. Before use, ensure that
there are no cracks in the diamond dry-cutting
disc.
•
Diamond dry-cutting discs are designed for
straight cuts. If used to cut curves the blade
becomes deformed, causing internal cracks and
segments to break off (see "Chap. 2.10 Intended
use") – Risk of injury!
•
The diamond cutter should plunge into the
11
wall only after the working speed has been
reached – green LED (1) lights up.
•
After approx. 2 minutes of cutting time the ma-
chine should be run with no load for 10 seconds,
so that the diamond dry-cutting discs can cool.
9

Tools and Accessories

•
BAIER diamond dry-cutting discs for all kinds
of different areas of use (see "Chap. 7 Recom-
mended uses for BAIER diamond dry-cutting
discs").
•
BAIER special dust extractor
•
Professional whetstone (ID. No. 15453)
•
BAIER dust deflector for BDN 511
(ID No. 7342)
•
BAIER ring disc set BDN 511, contains 6 ring
discs, 3 mm thick (ID No. 9189)
•
Baier BFS (walk-behind system) for mounting
onto BDN 511 with round pin plug (EU)
(ID No. 7336)
•
Baier BFS (walk-behind system) for mounting
onto BDN 511 with NEMA 6 (USA) (ID No. 9082)
10

Disposal

Recycle the machine and its packaging
in an environmentally friendly way in
accordance with the provisions applicable
in your country.