Adjust Cutting Depth; Connect Dust Extractor; Switch On The Diamond Cutter And Cut - Baier BDN 511 Traduction De La Version Originale Du Mode D'emploi

EN
4.2

Adjust cutting depth

•
8 / 9 Use an open-ended spanner, size SW13
to undo the hexagon nut (1) on the protective
hood (2).
•
8 / 9 Turn the protective hood (2) to adjust the
cutting depth (Δ).
•
8 / 9 Tighten hexagon nut (1).
4.3

Connect dust extractor

•
Check the dust extractor to ensure that it is
working properly.
•
Push the dust extractor hose (3) firmly onto
10
the nozzle (2) of the protective hood (1).
NOTE
The nozzle (2) is designed to fit the suction hose
(3) of a BAIER special dust extractor.
When the suction hose (3) is cold, a good deal
10
of effort is required to push it onto the nozzle (2) of
the diamond cutter.
4.4 Switch on the diamond cutter
and cut
•
11 Always hold the diamond cutter with both
hands on the handles (4) / (7).
•
11 Position the front roller (6) on the wall – the
diamond dry-cutting discs must not touch the
wall.
•
11 Switch on the diamond cutter at the switch
(3) and wait until the working speed has been
reached – the green LED (1) lights up.
•
11 Plunge the diamond dry-cutting discs
uniformly into the wall – the green LED (1) must
not go out.
•
As soon as the rear roller (5) touches the
11
wall, the diamond cutter can be pushed in the
direction of the planned chase.
•
Working direction  of the diamond
/
1 11
cutter.
| 38 |
NOTE
The diamond dry-cutting disc can become blunt or
damaged due to overheating. An overheated (blue
tarnished) diamond dry-cutting disc can usually no
longer be resharpened.
Î The feed can only be as high as the diamond
dry-cutting disc can wear away the material.
Therefore, do not exert too large a force on the
diamond dry-cutting discs and avoid canting.
Note and follow the information and instructions
on handling diamond dry-cutting discs (see
page 40).
11 If the feed is too fast, the red LED (2) lights up.
Then, reduce the feed immediately until the green
LED (1) lights up again.
If this warning signal is ignored, i.e. the feed is not
reduced, the electronics switch off on overload.
WARNING
Risk of injury due to uncontrolled kickback of the
diamond cutter, caused by canting of the diamond
cutter in the cut chase.
Î Always wait for the diamond dry-cutting discs to
stop completely before removing the diamond
cutter from the cut chase.
The cutting process can then be started and contin-
ued as described above (see "Chap. 4.4 Switch on
the diamond cutter and cut").
NOTE
The diamond cutter also switches off if the
diamond dry-cutting disc has insufficient cutting
power. In this case, check whether you have
chosen the correct diamond dry-cutting disc for
the relevant area of use (see selection table for
diamond dry-cutting discs on page 40).
Note and follow the information and instructions
on handling diamond dry-cutting discs (see
page 40).