Eu Declaration Of Conformity; Machine Characteristics; Machine Parts And Controls; Intended Use - Baier BDN 511 Traduction De La Version Originale Du Mode D'emploi

2.7

EU Declaration of Conformity

We herewith declare, with sole responsibil-
ity, that this product conforms to the follow-
ing standards or normative documents:
in accordance with the provisions of the
2006 / 42 / EC; 2014 / 30 / EU; 2011 / 65 / EU
The head of development is authorised to
write the technical documents.
These are available from:
Maschinenfabrik OTTO BAIER GmbH,
Heckenwiesen 26,
71679 Asperg
Thomas Schwab
Managing Director
Asperg, 02.05.2019
2.8

Machine characteristics

The machines are equipped with specially
developed electronics. It monitors the speed and
the green / red indicator lights (items 14 and 15,
see Figure 1 ) help to achieve the most favourable
work progress and therefore tool-protecting working
conditions.
Visual display
Green: Speed for optimum cutting performance
Red: Speed too low – stopping
If this warning signal is ignored, i.e. the feed is not
reduced, the electronics switch off on overload.
After the diamond dry-cutting discs have stopped,
remove them from the chase. The machine can be
immediately restarted.
EN 60745
Directives
Germany
Robert Pichl
Head of Development
2.9

Machine parts and controls

(See Figure 1 )
1 ON / OFF switch
2 Rear handle
3 Nozzle for dust extractor hose connection
4 Rear roller
5 Rotational direction arrow on protective hood
6 Dust deflector
7 Hexagonal screw (left-hand thread)
8 Washer
9 Rotational direction arrow on diamond
dry-cutting disc
10 Diamond dry-cutting disc
11 Protective hood
12 Front roller
13 Front handle
14 Green LED
15 Red LED
 Working direction

2.10 Intended use

The diamond cutters listed in this instruction manual
are only approved for dry cutting in masonry (brick,
lime-sand blocks, undressed stone) and concrete.
They must not be used for wet cutting or for cuts in
metal, glass, wood, etc.
•
Observe the relevant regulations in your
country for the materials to be machined.
•
The diamond cutters are only approved for
use together with a dust extractor, which is
suitable for stone dust (e.g. BAIER Special Dust
Extractor).
WARNING
Risk of injury due to cracking and breaking of
the diamond dry-cutting disc (bits of disc flying
around).
Î Diamond dry-cutting discs are designed for
straight cuts.
If used to cut curves the diamond dry-cutting
disc becomes deformed which causes internal
cracks and segments to break off.
•
Do not expose diamond dry-cutting discs to
lateral pressure.
•
Never use diamond dry-cutting discs for rough
grinding.
| 35 |