Functions; Normal Mode - Lanaform Notus Mode D'emploi

EN

Functions:

• Air humidifier
• Eliminates electrostatic charges
• Improves ambient air quality
Differences between warm mist and cool mist (advice on use):
• Early-age child/children
Give preference to using cool mist which is far less hazardous and will not cause burning/burns in the event of the appliance
being dropped or tipped over.
• Maintenance
When diffusing cool mist the appliance requires cleaning with greater frequency than when diffusing warm mist. In actual
fact, when producing warm mist, the water is heated passing through a heater that eliminates large quantities of bacteria.
Accordingly, since the NOTUS offers both these functions, it is most important that you refer to the maintenance instructions in
this manual.
• Room in which the humidifier will be installed
Cool mist will add a touch of freshness in a stuffy, dry and poorly ventilated room. As for warm mist, it will heat the air in a cool
room.
• Power consumption
The warm mist function consumes more power since it needs to heat up the water to generate the warm mist.
Fitting the demineralisation filter:
Fasten the demineralisation filter to the inside surface of the tank cap by rotating it clockwise as shown in scheme 3, item (h).
Conversely, to remove the demineralisation filter, rotate it counter-clockwise.
Instructions for use (see illustrations, scheme 3):
1) Place the "NOTUS" humidifier in the room half an hour before switching it on to allow it to adapt to ambient temperature.
2) Make sure it is always placed on a hard, flat and level surface (a). Keep it slightly away from walls and heat sources such as
stoves, radiators, etc.
3) Make sure the appliance is clean before starting to use it.
4) Remove the tank grasping its handle (e) and hold it upside down (f). Turn the tank cap anti-clockwise to open it. Next pour
fresh, distilled or demineralised water into the tank. Replace the cap and rotate clockwise to seal it hermetically (g) (f).
Finally, fit the tank correctly to the base of the appliance (e) (b, c, d).
5) Make sure your hands are completely dry when connecting and disconnecting the appliance and if they are not, then dry
them.
6) Press the "On/Off" button (item 11, scheme 2). It will take approx. 1 second to start up, this time is required to check the
water level. If the water level is sufficient, an audible signal will sound.
7) At this point the humidifier is operational. It will be operating in "normal mode" with warm mist, which is the default mode.
It can take some ten minutes for warm mist to be generated depending on the ambient temperature in the room.

NORMAL MODE:

- If you wish to change the mist output level, press the "More" or "Less" button, as appropriate (items 15 & 10, scheme 2).
- If you wish to stop warm mist generation , press the "Hot/Cool" button (item 12, scheme 2) and the indicator will
disappear.
- If you wish to programme a specific humidity level, press the programming button (item 14, scheme 2). Proceed likewise
to programme the timer, i.e. press the programming button twice in succession and programme the timer up to maximum
of 8 hours in 1 hour steps.
- If you wish to change modes and go into one of the 3 preprogrammed modes, all you need do is press the mode change
button and select the desired mode (item 13, scheme 2).
6