Lanaform Notus Mode D'emploi page 8

EN
3) Changing the water in the tank every 2 days.
4) Cleaning the appliance (see explanations below) and making sure that all its parts are completely dry when it is not in use.
To clean the transducer (white ceramic disc (i)):
1) Pour 2 to 5 drops of vinegar onto its surface and leave them for 2 to 5 minutes.
2) Brush the sediment off the surface with a soft brush (j). Do not use a hard tool to scrape the surface.
3) Rinse out the base tank using clean water.
4) Do not use soap, solvent or spray cleaner to clean the transducer.
To clean the basin unit:
1) Clean the basin with water using a soft cloth and vinegar if there is any sediment or limescale deposit on the inside.
2) Rinse the basin in clean water.
To clean the mist discharge nozzle on the appliance:
1) Clean it with a brush or damp cloth.
2) Rinse the nozzle in clean water.
Storage
Having cleaned and dried the appliance, store it in a dry, cool place out of reach of children.
TROUBLESHOOTING
In the event of a malfunction, under normal conditions of use, please refer to the following chart:
Effects
No steam, no light showing.
Mist has an unusual smell.
Low output.
8
Possible causes
If there is no light.
The water level in the tank is too low.
Water is leaking from the tank.
The temperature of the unit is too low.
The water has been standing in the
tank too long.
Too much/too little water in the tank.
Sediment on the transducer.
The water is too cold.
The water is not clean.
Solutions
Check that the appliance is connected
and that there has not been a mains
power failure.
Add water to the tank.
Check that the tank has been fitted
correctly.
Place the unit in a room at ambient
temperature for half an hour prior to
use.
Clean the tank and fill it with fresh,
distilled or demineralised water.
Empty water out of the tank or top
it up.
Clean the transducer.
Use water that is at room temperature.
Clean the tank and fill it with fresh,
distilled or demineralised water.