Leister WELDPLAST S1 Notice D'utilisation page 34

Entering names or passwords
• In keyboard mode, you can define names or enter passwords with a maximum of 12 characters.
Keyboard mode
27
Defining profiles
• In the «Save Profile» menu, you can save setpoint settings for the max. output volume, the plasticizing/air tem-
perature, and the air output and give the profile a name (see «Entering names or passwords» chapter).
• Creating a new profile:
– In the working display (28), set the required setpoints using the «Plus»
– In the function display (27), select the Settings menu
– In the «Setup» menu, select «Save Profile» with the «Plus» key (26)
– Select the «User-defined» profile and confirm with the relevant key (25)
– In the function display (27), select the «Edit selected item» symbol
(25)
.
– Enter the desired profile name (see "Entering names or passwords" chapter), then select the
with the «Plus» key (26)
– In the function display (27), confirm the selected «Save» symbol
profile has now been successfully saved and selected.
34
Character selection
Up (21)
Vertical character selection
Down (22)
Minus (24)
Horizontal character selection
Plus (26)
Confirmed (25) Confirm the selected character
34
35
and confirm with the relevant key (25)
34
Change between upper and lower case
Move the cursor in the name
Insert blank space
Delete one character (the character to the left of the cursor)
Select this symbol to switch to the
function display 27
with the «Plus» key (26)
Symbol selection 35
Symbol selection
Confirm the selected symbol
or «Minus» keys (24/26).
.
.
.
and confirm with the relevant key
.
with the relevant key (25)
symbol
. The