Ameriphone Q90D Mode D'emploi page 14

Installing and Using Your Q90D
7. If the other party answers by TTY, the
SIGNAL light brightens and a greeting
message is displayed on the screen. If
the other party answers by voice, the
SIGNAL light flickers. If Auto ID is ON,
the Q90D sends Baudot tones to tell the
person you are calling that this is a TTY
call.
8. If the line is busy, BUSY SIGNAL!!!! is
displayed and the red SIGNAL light
(located above the F12 key) flashes
quickly. Hold down CTRL and F1 to hang
up which also causes the SIGNAL light to
stop flashing.Try dialing again.
9. After the conversation is over, hold down
CTRL and press Power to turn OFF the
Q90D.To hang up and make another call,
hold down CTRL and press F1.
10. Slide the LOCK to the ON position if
moving the Q90D from one location to
another.
Dialing from a Digital Cellular or
Cordless Telephone
1. Press Power to turn ON the Q90D.
2. Dial the telephone number using the
cellular or cordless telephone.
3. If the line is not busy, SILENCE!!!! and
RINGING will be displayed alternately.
4. If the other party answers by TTY, the
SIGNAL light brightens and a greeting
message is displayed on the screen. If
the other party answers by voice, the
SIGNAL light flickers. If Auto ID is ON, the
Q90D sends Baudot tones to tell the per-
son you are calling that this is a TTY call.
5. If the line is busy, BUSY SIGNAL!!!! is
displayed and the red SIGNAL light
(located above the F12 key) flashes
quickly. Hold down CTRL and F1 to hang
up which also causes the SIGNAL light to
stop flashing.Try dialing again.
6. After the conversation is over, hold down
CTRL and press POWER to turn OFF the
Q90D and turn off your cellular or
cordless phone.
7. Slide the LOCK to the ON position if
moving the Q90D from one location to
another.
Placing VCO or HCO Calls
You can also make Voice Carry Over (VCO)
or Hearing Carry Over (HCO) calls with your
Q90D.
Voice Carry Over (VCO) Calls
(Factory setting is OFF.)
Voice Carry Over (VCO) is for people who
can speak, but have difficulty hearing.These
calls are made through a Relay Service with
the help of a Relay Service Communications
Assistant (CA).This feature allows the
outgoing conversation to be voiced, while
providing a text display of the incoming
response.
Since the VCO mode is not automatically set
in the ON position, you must turn it ON for
each VCO conversation. When the VCO
mode is ON, the built-in microphone
automatically switches to ON so you can
speak into it when the other party sends you
the GA message. If the microphone does not
turn ON automatically, hold down CTRL and
press F5 to turn it ON manually.
10