Operation; Brewing A Carafe - Breville the BrevillePrecision Brewer Glass BDC400 Manuel D'instructions

Setting the water hardness level in your
machine can prevent scale build-up.
Scale build-up can affect the brewing flow of
the machine, the brewing temperature and the
taste of the coffee.
To ensure good coffee results, it is important
to select the right water hardness level before
brewing coffee for the first time.
Follow the steps below:
WATER HARDNESS SETTING AND
FLUSHING FOR FIRST TIME USE
1. Ensure that the empty coffee basket and
empty carafe (with assembled lid) are
inserted into the machine.
2. Fill the water tank with fresh cold water to
the MAX mark on the water tank. Plug into
power outlet.
3. When first turned on, the machine will
show 'HArd' on LCD, asking for the water
hardness level (refer to important note
above). Press SELECT dial once. Dip the
water hardness test strip into the filled
water tank for 1 second, remove and wait
for 1 minute to reveal the result. Rotate
SELECT dial and press the dial to select
the level according to the number of red
dots shown on the strip. To reset water
hardness, please refer to FACTORY RESET
(page 19).
4. The machine will show 'FLUSH Unit'
on LCD. Press SELECT dial once. The
machine will dispense all the water from
the tank, through the system & into the
empty carafe. After flushing, empty the
basket and carafe.
BDC400_USC_IB_D20.indd 11

Operation

BREWING A CARAFE

Ensure the brew basket is clean and the drip
stop seal in the bottom of the basket is clean
and free of coffee particles.
1. Select the correct basket & filter for the
amount of coffee you're making. When
brewing between 2 and 8 cups, we
recommend you use the Cone shaped filter
basket insert with paper filter (Cone paper
filter is not included). When brewing more
than 8 cups, use mesh basket filter or flat
bottom brew basket with large paper filter.
OR
✔
2 - 8
CUPS
CAUTION
Filling the basket without a mesh basket filter
or filter paper may cause the basket to overflow
during the brewing cycle.
2. The LCD will display the basket setting -
"Basket" or "Cone". To change the basket
type, rotate the SELECT dial to Settings &
press the dial. Rotate the SELECT dial to the
basket type, press the SELECT dial to set.
3. Fill the water tank with fresh cold water up
to the MAX marking on the water tank.
OR
✔
8+
CUPS
11
24/1/20 9:59 am