Maintenance; General; Daily Cleaning; Replacing A Display Light - Hatco GLOMAX GMFFL Manuel D'installation Et D'utilisation

MAINTENANCE

General

Hatco GLOMAX Portable Foodwarmer units are designed for
®
maximum durability and
maintenance.
WARNING
ELECTRIC ShOCk hAzARD:
• Turn power switch OFF, unplug power cord, and allow
unit to cool before performing any maintenance or
cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized hatco Service
Agent or contact the hatco Service Department at
414-671-6350; International fax 414-671-3976.
Use only Genuine hatco Replacement Parts when service
is required. Failure to use Genuine hatco Replacement
Parts will void all warranties and may subject operators of
the equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine hatco Replacement Parts
are specified to operate safely in the environments in
which they are used. Some aftermarket or generic
replacement parts do not have the characteristics that will
allow them to operate safely in hatco equipment.
NOTICE
Clean unit daily to avoid malfunctions and maintain
sanitary operation.
performance with minimum

Daily Cleaning

To preserve the bright finish of the unit it is recommended that
the exterior surfaces be cleaned daily.
Use non-abrasive cleaners only. Abrasive cleaners could
scratch finish of unit, marring its appearance and making
it susceptible to soil accumulation.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Remove food pans and any accessories for proper
cleaning in a dishwasher or wash sink.
3. Wipe down all metal surfaces using a soft, damp cloth.
Stubborn stains may be removed with a good non-abrasive
cleaner. Hard to reach areas should be cleaned with a
small brush and mild soap.

Replacing A Display Light

Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially coated could result in personal injury and/or
food contamination.
The display lights are incandescent light bulbs that illuminate
the warming area. The bulbs have a special coating to guard
against injury and food contamination in the event of breakage.
Use the following procedure to replace a bulb.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Unscrew the light bulb(s) from the unit and replace with a
new specially-coated incandescent light bulb(s).
NOTE: For 120 Volt applications, use Hatco P/N 02.30.043.00.
For 230 Volt applications, use Hatco P/N 02.30.058.00.
8
NOTICE
WARNING
Form No. GMFFLCEM-0810