Publicité
Les langues disponibles
Les langues disponibles
Installation
• Cut the hose connector to the desired diameter and fasten this to the pump.
• Connect the pond hose to the hose connector using a hose clamp (not supplied).
• Install the pump in your pond at least 20 cm below the surface of the water. Make sure
that the pump is seated firmly.
• The Pump ECO pump should always be used at maximum power. This prevents possible
clogging and ensures that sufficient water is transported to the filter. Make sure that
the knob, on the front of the pump, is always at the maximum (+) position. Always place
the pump in the deepest part of the pond to maximize the removal of dirt.
• When used inline, outside of the pond; make sure the pump gets enough water supply
and does not run dry, make sure all connections are 100% waterproof, leakage may lead
to an empty pond and cause harm to your fish and plants.
• Never lift the pump out of the water by pulling the power cord.
Maintenance
• Remove the pump from your pond during frosty periods and clean it well and store it in
a dry place free from frost.
• Your pump needs regular cleaning, see page 10, there is no warranty on failures due to
dirty pumps and scale build up inside the pump caused by improper maintenance.
• Depending on usage the rotor of your pump can get worn out and damaged, this is
normal, new rotors can be purchased at your dealer.
• Damage of cable, rotor or other parts due to wrong usage, is not covered by warranty!
Technical specifications
Model
Voltage
Power
Pump capacity
Max. head of water
Connection
Cable length
Pond ECO 2900
220-240 V/50 Hz
14 W
3,500 l/h
2.00 m
40/32/25 mm
10 m
Pond ECO 4900
220-240 V/50 Hz
29 W
5,300 l/h
3.20 m
40/32/25 mm
10 m
3
Publicité
