Table des Matières
Publicité
Compliance
IC statement: CAN ICES-3 (B)/NMB-3 (B)
This device complies with Industry Canada licence-exempt RSS standard(s)
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
FCC statement (for USA only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation. This equipment has been tested and found
to comply with the limits for a Class B digital device. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures: Reorient or relocate the receiving antenna; Increase the separation
between the equipment and receiver; Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected; Consult the dealer
or an experienced radio/television technician for help.
Compliance with safety standards
- Meets applicable UL safety standards. Certified by CSA Group, a Nationally
Recognized Testing Laboratory (NRTL).
- CSA C22.2 No. 0-10 General Requirements – Canadian Electrical code, part II.
- CSA C22.2 No. 281.1-12/UL2231-1 Standard for safety for personnel
protection systems for electrical vehicle (EV) supply circuits: General
requirements.
- CSA C22.2 No. 281.2-12/UL2231-2 Standard for safety for personnel
protection systems for electric vehicle (EV) supply circuits: Particular
requirements for protection devices for use in charging systems.
- CSA C22.2 No. 280-13/UL2594 (1st edition) Electric vehicle supply
equipment (EVSE).
- CSA C22.2 No. 0.8-12 Safety functions incorporating electronic technology.
- UL1998 Standard for software in programmable components.
- UL991 Standard for Tests for Safety-Related Controls Employing
Solid-State Devices.
- NEC 2014 section 625.
FLO Home X5 | Installation guide | flo.com | September 2018
254081
17
Publicité
Table des Matières
