Table des Matières
Publicité
Station Status
light indicator
Green
- Solid color (not blinking): powered station, ready for use
- Blinking slowly: vehicle charging completed
White
- Solid color (not blinking): connector connected to the
vehicle, without energy transfer (waiting for the time
schedule configured by the user)
- Blinking quickly: session permission obtained (this state is
created when using the mobile application or the user web portal
to start a remote session)
- Blinking slowly: waiting for an energy transfer request (check
that the vehicle is switched off)
Blue
- Solid color (not blinking): connector plugged in, unrestricted
power transfer (in full power mode)
- Blinking slowly: connector plugged in, power transfer with
restriction (in reduced power mode)
Orange
- Solid color (not blinking): deactivated completely or
inaccessible according to the access schedule
Red
- Solid color (not blinking): major fault requiring a power cut on
the circuit breaker
- Blinking slowly: major fault requiring a restart of the current
session (please unplug the vehicle connector and restart your
session)
Connectivity and Illumination LED
White to Blue
- Blinking slowly from white to blue: initial phase of detection
of a second station (only at start-up for
White
- Solid color (not blinking): the station is connected to the FLO
server and the white light guides the insertion of the connector
- Blinking slowly: the station cannot connect to the FLO
server (check the PLC installation)
Blue
- Solid color (not blinking): the station is connected to the FLO
server and is in power sharing mode with another X5 station
- Blinking slowly: the station cannot connect to the FLO
server (check the PLC installation)
Yellow
- Blinking quickly: the station is in configuration mode with the PLC
module (after 3 minutes the terminal will restart)
2 minutes)
Publicité
Table des Matières
