shark GS300 Série Manuel Du Propriétaire page 4

QUICK START GUIDE
ASSEMBLY
1 Set the base on the floor and
insert the telescoping pole, align
the groove of the pole with the
arrow on the base. Turn the pole
connector clockwise to secure.
(fig. 1)
2 Attach the steam nozzle cradle to
the telescoping pole. The garment
hook should face away from the
front of the base. (fig. 2)
4 TOLL FREE: 1-800-798-7398
fig. 1
3
3 Pull the release button (3) on the
base towards you. (2) Holding
the unit at a slight angle align
the slot on the front of the unit
with the base rib and insert it into
the base. (1) Then push down
to engage the latch. Then push
the release button in to lock it in
place. (fig. 3)
fig. 2
1
2
fig. 3
4 Align the notch on the inside of the
hose connector to the steam unit
and turn the connector clockwise.
Hang the steam nozzle on the
steam nozzle cradle. (fig. 4)
NOTE: The hose will remain stiff
until heated.
5 Adjust the telescoping pole to the
desired height.
fig. 4