Cleaning & Storing; Replacement Parts - shark GS300 Série Manuel Du Propriétaire

MAINTENANCE
CLEANING & STORING
1 Turn the steamer off "0" and
unplug from the electrical outlet.
Let the steamer cool for 30
minutes and empty the water
from the tank.
2 Hang the steam nozzle on the
cradle.
TROUBLESHOOTING GUIDE & REPLACEMENT PARTS
PROBLEM
There is no steam.
The nozzle leaves water drops
on the garment.
Gurgling/Inconsistent Steam Flow
Unit won't turn on.

REPLACEMENT PARTS

A 100SDL Bristle Brush Frame
B XPD300
Steam Bonnet
To order any of the above replacement parts, go to www.sharkclean.com or call 1-800-798-7398.
10 TOLL FREE: 1-800-798-7398
3 Collapse the telescoping pole
for compact storage. Wipe the
exterior of the steamer with
a damp cloth and wipe dry if
needed.
SUGGESTED SOLUTION
1 Make sure the unit is plugged in and turned on.
2 The water tank might be empty, add water.
3 The water cap is not fully pushed in, press the cap down and turn clockwise
to secure tightly making sure the arrows are aligned.
1 Make sure the steam bonnet is attached to the nozzle.
2 The steam bonnet could be too wet, remove the bonnet and let it dry
before reusing.
3 The steam hose is bent, straighten the hose to eliminate condensation
build up.
1 The hose may be bent trapping steam or condensation. Simply straighten
the hose to eliminate condensation build up.
2 In portable usage the unit must be level to the floor with the hose extended
to generate continuous steam.
1 Make sure the unit is plugged in and turned into the "I" position.
4 Store the steamer in a cool
dry place.
5 We recommend to remove the
steam hose from the steam unit
and turn the water tank upside
down over the sink to empty any
excess water once a week. This
will prolong the life of the garment
steamer.