Maintenance - Campbell Hausfeld VT4700 Mode D'emploi

assembly (Continued)
bReak-In
After installing compressor, start the
new pump and run without a load (0
PSI) for 30 minutes. With a pressure
regulator set to 40 PSI and no tool or
hose connected to the outlet, run the
compressor for another 30 minutes.

Maintenance

Disconnect, tag and lock out
power source, then release
all pressure from the system
before attempting to install, service,
relocate or perform any maintenance.
FOR eFFICIent OPeRatIOn beFORe
eaCh USe:
1. Check air filter.
2. Check oil level. Low oil level will
result in rapid wear and short pump
life.
Sight
Glass
Oil Drain Plug
Figure 2 - Oil Fill
Figure 3
tORqUe ReqUIReMentS (In/lbS.)
Compressor head
bolts
bearing Cap bolts
Flywheel bolt
Operation
Check Oil Level
Check Air Filter
Change Oil
MOIStURe In COMPReSSeD aIR
Moisture in compressed air will form into droplets as it comes from an air
compressor pump. When humidity is high or when a compressor is in continuous
use for an extended period of time, this moisture will collect in the tank. When
using a paint spray or sandblast gun, this water will be carried from the tank
through the hose, and out of the gun as droplets mixed with the spray material.
IMPORtant: This condensation will cause water spots in a paint job, especially
when spraying other than water based paints. If sandblasting, it will cause the
Breather
sand to cake and clog the gun, rendering it ineffective.
A filter in the air line, located as near to the gun as possible, will help eliminate
this moisture.
Oil Fill
Hole
Full
Add Oil
Single-Stage Compressor Pumps
teChnICal SeRvICe
For information regarding the
all vt models
operation or repair of this product,
175 - 225
please call 1-800-543-6400.
50 - 120
225 - 250
MaIntenanCe SCheDUle
Daily
l
Insufficient oil change intervals will shorten pump life
3
Weekly 3 Months
l
l
www.chpower.com