Elite DIGITAL SMART B+ Mode D'emploi page 17

roller.
-Do not store Digital Smart B+ in wet or damp places. The
electronic components could become damaged.
-Digital Smart B+ may not comply with the EC directives if
the power adapter supplied (ref. B) is not used.
-If slipping of the wheel on the Elastogel roller is noticed,
apply a more gradual force on the pedal. Training with the
tyre slipping can permanently damage the Elastogel roller.
12_TROUBLESHOOTING
The trainer doesn't change the resistance:
if you're having trouble connecting, try removing all
electronic devices (such as Smartphones and/or wireless
routers) or changing the transmission channel ¹ and repeat
the pairing process with the app/software/cycle computer
again.
The cadence value is not accurate:
the algorithm that calculates cadence without a sensor can
sometimes vary in accuracy. This might happen when
training with a high pedaling cadence at a low resistance
level. For higher accuracy, use cadence sensors-the wire-
less ELITE sensor that connects to the hometrainer- or
other wireless devices that send data directly to the sof-
tware/app.
If the hometrainer does not connect to the app / cycle
computer:
The hometrainer needs to be properly powered up to work
and it needs to connect to a device within 2 minutes,
otherwise it will automatically enter its energy saving
phase. Start pedaling or unplug it and plug it in again to
reactivate it, and then connect to a device within 2 minu-
tes.
If the LED light on the motherboard does not blink:
Use a tester to check if the power charger is malfunctioning.
¹ The ANT++ and Bluetooth Smart transmission systems
are compatible with the Wi-Fi standard, so there is usually
no need to turn off your Smartphone and router. The Wi-Fi
signal might occasionally interfere with data transmission,
in which case it's important to make sure that the Wi-Fi
network uses a channel that is either14 or less than 6.
Channels 7 through 13 might interfere with the
hometrainer's ANT+ or Bluetooth wireless transmission
system.
13_INFORMATION ON PRODUCT DISPOSAL
1) WITHIN THE EUROPEAN UNION
This product conforms with European Directives 2002/95/
CE, 2002/96/CE and 2003/108/CE.
The crossed bin symbol given on the equipment
or on the packaging indicates that at the end of its
service life the product must be collected separa-
tely from other waste.
Therefore at the end of its useful life the user must take
the equipment to an appropriate centre for the differentia-
ted collection of electronic and electrotechnical waste, or
return it to the dealer when purchasing a new product of
equivalent type.
Adequate differentiated collection for subsequent sending
of the scrapped equipment to recycling, treatment and en-
vironmentally-friendly disposal can help prevent possible
negative consequences for the environment and the health
of people and favours the resume and/or recycling of the
materials from which the equipment is made.
Improper disposal of the product by the user could involve
penalties as specified by the regulations in force.
2) IN NON-EU COUNTRIES
If you want to dispose of this product, please contact your
local authorities and ask them what disposal method ap-
plies.
EN
17