Troubleshooting Guide; Replacement Parts; Ordering Replacement Parts - Euro-Pro NINJA QB1000C Guide D'utilisation

Troubleshooting Guide

PROBLEMS
Motor Doesn't Start or Blade
Assembly Doesn't Rotate.
Food is Unevenly Chopped.
Food is Chopped Too Fine or is
Too Watery.
Food Collects On Splashguard or
On the Sides of the Master Prep
Pitcher or Master Prep Bowl.
You Cannot Achieve Snow From
Solid Ice.

Replacement Parts

ORDERING REPLACEMENT PARTS

To order additional parts and attachments, please visit our website: www.ninjakitchen.com
or feel free to contact customer service: 1-877-646-5288.
POSSIBLE REASONS & SOLUTIONS
Check that the bottom of motor head is clean and there is no food blocking
connection when placing on containers.
There is too much food in the container.
The unit has overheated or overloaded. Unplug and wait approximately 10
minutes before using again.
Make sure the splashguard is securely on container.
Make sure the Master Pod is securely placed on splashguard.
Check that the plug is securely inserted into the electrical outlet.
Check fuse or breaker. Replace fuse/reset breaker.
Either you are chopping too much food at one time, or the pieces are not small
enough. Try cutting the food into smaller pieces of even size and processing
smaller amounts per batch.
The food has been over processed. Use brief pulses or process for shorter time.
Let blade assembly stop completely between pulses.
You may be processing too much food. Turn the machine off. When the blade
assembly stops rotating, remove the Master Pod and the splashguard. Remove
some of the food being processed.
Do not use ice that has been sitting out or has started to melt. Be sure to use
short pulses in the beginning to break up large pieces.
www.ninjakitchen.com 14