Master Prep - Euro-Pro NINJA QB1000C Guide D'utilisation

WARNING: Handle the Ninja
WARNING: Remove utensils prior to processing. Failure to remove may cause the pitcher to be damaged or
to shatter, which may cause personal injury.
WARNING: DO NOT try to place the Ninja 6-Blade Assembly onto the Master Pod and then into the pitcher.
WARNING: DO NOT attempt to operate the appliance without the safety splashguard in place.
WARNING: Never leave the appliance unattended while in use.
CAUTION: DO NOT blend hot liquids, doing so may cause excessive pressure buildup, resulting in risk of
the user being burned.
IMPORTANT: Make sure that the Master Pod is plugged in for use.
4
Add the ingredients to be processed into the Master
Prep Professional pitcher.
®
IMPORTANT: Never add ingredients into the Master
Prep Professional pitcher before placing the blade
assembly in first.
5
Place the pitcher splashguard onto the top of the
Master Prep Professional pitcher. (fig. 2)
6
Place the Master Pod on top of the pitcher splashguard
making sure that it is securely in place. (fig. 3) DO
NOT attempt to operate the appliance without the
safety splashguard in place.
7
To start the appliance, plug the power cord into the
electrical outlet, securely hold power head while
operating and press on the on/off pulse button located
on the top of the power head. (fig. 4)
8
Hold the Master Prep Professional pitcher firmly while
depressing the on/off pulse button to ensure the unit
stays in place.
NOTE: DO NOT operate the appliance continuously for
more than 15 seconds at a time.
6-Blade Assembly with care, as the blades are sharp.
®
Fig. 2 Fig. 3
9
To stop the appliance, remove your fingers from the On/
Off pulse button.
10 In order to obtain a better quality of chopping, operate
the appliance by using the "pulse" method.
11 Make sure that the Ninja 6-Blade Assembly has
stopped completely before removing the Master Pod.
12 If the ingredients stick to the side of the Master Prep
Professional pitcher, stop the appliance, remove the
Master Pod and the splashguard. Use a spatula to
dislodge the pieces and then replace the splashguard
and the Master Pod. Continue processing.
13 Depending on the consistency of the contents, use the
pouring spout to empty liquid contents.
14 For thicker consistencies, first remove the pitcher
splashguard. Then, carefully remove the Ninja 6-Blade
Assembly by the top of the shaft. Place blade assembly
away from the work area to avoid accidental contact.
Finally, empty contents from the pitcher.
HINTS & TIPS FOR USING YOUR NINJA
PREP PROFESSIONAL
®
•
To crush ice into snow, start by using short pulses to
break up large chunks. Continue until snow is achieved.
Fig. 4
MASTER
®
www.ninjakitchen.com
®
10