Assembly And Use Of The Master Prep Bowl - Euro-Pro NINJA QB1000C Guide D'utilisation

Assembly and Use of the Master Prep
WARNING: Handle the Upper and Lower Chopping Bowl Blade Assemblies with care, as the blades are
sharp.
WARNING: Remove utensils prior to processing. Failure to remove may cause the bowl to be damaged or to
shatter, which may cause personal injury.
WARNING: DO NOT try to place the Blade Assemblies onto the Master Pod and then into the bowl.
WARNING: DO NOT attempt to operate the appliance without the safety splashguard in place.
WARNING: DO NOT crush ice in Master Prep Bowl or damage may occur to the unit.
WARNING: Never leave the appliance unattended while in use.
WARNING: Upper and Lower Chopping Bowl Blade Assemblies are loose and not locked in place. Make
sure to remove the Chopping Blade Assembly before emptying contents of processor bowl.
IMPORTANT: Make sure that the Master Pod is plugged in for use.
1
Review warning and caution statements at the top of
page before proceeding to number 2.
2
Place the Master Prep bowl on a clean, dry, level
surface.
3 Holding the Lower Chopping Blade Assembly by the
shaft, place it over the spindle pin inside the Master
Prep bowl. (fig. 1)
4 Carefully insert the Upper Chopping Blade Assembly
over the Lower Chopping Blade Assembly rotating it
until it locks onto the Lower Chopping Blade Assembly.
(fig. 2)
IMPORTANT: Always assemble the Chopping
Blade Assembly inside the container.
11 1-877-646-5288
Shaft
Fig. 1
Bowl
®
Fig. 2
WARNING: DO NOT try to place the Chopping
Blade Assembly onto the Master Pod and then
into the Master Prep bowl.