Care & Maintenance; Resetting The Motor Thermostat - Euro-Pro NINJA QB1000C Guide D'utilisation

Care & Maintenance
HOW TO CLEAN
WARNING: DO NOT immerse the Master Pod into
water or any other liquid.
CAUTION: Make sure that the Master Pod is
unplugged from the power source before inserting
or removing any attachment and before cleaning.
1
Separate/remove all parts from each other.
2 Hand Washing: Wash the lids, splashguards, pitcher,
bowl and Blade Assemblies in warm, soapy water. When
washing the Blade Assemblies, use a dish-washing
utensil with a handle to avoid direct hand contact with
blades. Handle the Blade Assemblies with care to avoid
contact with sharp edges. Rinse and air dry thoroughly.
Dishwasher: The pitcher, bowl, lids, splashguards,
and Blade Assemblies are all dishwasher safe. It is
recommended that the lids and blade assemblies be
placed on the top rack. Ensure the blade assemblies are
removed from the pitcher and the bowl before placing in
the dishwasher.
WARNING: Handle the Blade Assemblies with care
when washing, as the blades are sharp. Contact
with the blades' edges can result in laceration.
3 Wipe the motor base clean with a damp cloth.
Please call customer service if any servicing needs to
be performed on the appliance at 1-877-646-5288.
13 1-877-646-5288
HOW TO STORE
1
Store the Master Prep
Chopping Blade Assembly inside the Bowl and the
6-Blade Assembly inside the Pitcher. Place the
splashguards on the containers. Store the rest of the
attachments in a safe place where they will not be
damaged and will not cause a hazard. Loosely wrap the
power cord around the Master Pod.

RESETTING THE MOTOR THERMOSTAT

The Ninja Master Prep Professional features a unique
®
safety system which prevents damage to the unit's motor
and drive system should you inadvertently overload your
appliance. If the appliance is being overloaded, the motor
will stop. To reset the appliance, follow the resetting
procedure below:
1 Unplug the appliance from the electrical outlet.
2
Remove the Master Pod and splashguard and empty
the container and ensure that no food is jamming the
blade assembly.
3
Allow the appliance to cool for approximately 10
minutes.
4
Replace the splashguard and Master Pod onto the
container and re-plug the appliance into the electrical
outlet.
5
Proceed to use the appliance as before making sure not
to exceed the recommended maximum capacities.
with the Upper and Lower
®