The Ninja; Before First Use; Assembly And Use Of The Pitcher - Euro-Pro NINJA QB1000C Guide D'utilisation

Before First Use

WARNING: Ninja 6-Blade
®
Assembly is sharp and not locked
in place. If using the pour spout,
ensure that the splashguard
is fully on the pitcher. Failure
to do so will result in a risk of
laceration.
WARNING: If pouring
with the lid or splashguard
removed, ALWAYS remove
the Ninja 6-Blade Assembly
first, holding them by their
shaft. Failure to do so will
result in a risk of laceration.
PLEASE KEEP THESE IMPORTANT SAFEGUARDS
IN MIND WHEN USING THE APPLIANCE:
IMPORTANT: Make sure that the Master Pod is
plugged in for use.
IMPORTANT: Never add ingredients into the
container before placing the Blade Assemblies in
first.
IMPORTANT: Attachments are not
interchangeable.
IMPORTANT: DO NOT attempt to operate the
appliance without the splashguard on.
IMPORTANT: Never run the appliance empty.
IMPORTANT: Appliance accessories are not
intended to be used in the microwave as it may
result in damage to the accessories.
WARNING: DO NOT immerse the Master Pod into
water or any other liquid.
1
Remove all packaging material and labels from the
appliance. Separate/remove all parts from each other.
2
Wash the lids, splashguards, bowl, pitcher, and blade
assemblies in warm, soapy water. When washing the
blade assemblies use a dish-washing utensil with a
handle to avoid direct hand contact with blades.
WARNING: Handle the blade assemblies with care
when washing, as the blades are sharp.
3
Handle the blade assemblies with care to avoid contact
with sharp edges. Rinse and air dry thoroughly.
4
The pitcher, bowl, lids, splashguards, and Blade
Assemblies are all dishwasher safe. It is recommended
that the lids, spashguards and blade assemblies
be placed on the top rack. Ensure that the blade
assemblies are removed from the pitcher and the bowl
before placing in the dishwasher.
5
Wipe the motor base clean with a damp cloth.
9 1-877-646-5288

Assembly and Use of the Pitcher

1
Review warning and caution statements at the top of
page 10 before proceeding to number 2.
2 Place the pitcher on a clean, dry, level surface.
3 Holding the Ninja 6-Blade Assembly by the shaft,
place it onto the spindle pin inside the Master Prep
Professional pitcher. (fig. 1)
WARNING: DO NOT try to place
the Ninja 6-Blade Assembly
onto the Master Pod and
then into the Master Prep
Professional pitcher. Always
assemble the Ninja 6-Blade
Assembly inside the pitcher.
Shaft
Fig. 1
®
®