Grundig CMS 4200 Manuel De L'utilisateur page 32

SAFETY AND SET-UP _________________________
The mains plug/appliance coupler is
•
used as the disconnect device, the
disconnect device must remain readily
operable.
Danger of explosion if battery is
•
incorrectly replaced. Replace only with
the same or equivalent type.
Warning:
The battery (batteries or battery pack)
•
shall not be exposed to excessive heat
such as sunshine, fire or the like.
Before operating this system, check
•
the voltage of this system to see if it
is identical to the voltage of your local
power supply.
Do not place this unit close to strong
•
magnetic fields.
Do not place this unit on the amplifier
•
or receiver.
Do not place this unit close to damp
•
areas as the moisture will affect the life
of the laser head.
If any solid object or liquid falls into the
•
system, unplug the system and have it
checked by qualified personnel before
operating it any further.
Do not attempt to clean the unit with
•
chemical solvents as this may damage
the finish. Use a clean, dry or slightly
damp cloth.
When removing the power plug from the
•
wall outlet, always pull directly on the
plug, never yank on the cord.
32 ENGLISH
Changes or modifications to this unit
•
not expressly approved by the party
responsible for compliance will void
the user's authority to operate the
equipment.
The rating label is pasted on the
•
bottom or back of the equipment.
Battery usage CAUTION
To prevent battery leakage which
may result in bodily injury, property
damage, or damage to the apparatus:
Install all batteries correctly, + and - as
•
marked on the apparatus.
Do not mix old and new batteries.
•
Do not mix alkaline, standard (Carbon-
•
Zinc) or rechargeable (Ni-Cd, Ni- MH,
etc.) batteries.
Remove batteries when the unit is not
•
used for a long time.
Excessive sound pressure from the
•
earphones or headphones can cause
hearing loss.
Note:
Do not connect any other equipment
•
while the device is switched on. Switch
off the other devices as well before
connecting them.
Only plug the device into the mains
•
socket after you have connected the
external devices. Make sure the power
plug is freely accessible.