Fitting Instructions - Brevi Axo Mode D'emploi

GB
child's harness correctly and never attempt
to use it without fastening it into the car, as
described in these fitting instructions.
•
Never place any padding between the base
of the car seat and the vehicle's seat, as this
could impair the safety of the car seat.
•
Do not add to or modify this product, in any
way.
•
Never use spare parts that are not recom-
mended or supplied by the manufacturer.
•
Should any unauthorized modification be
made to this child seat, its safety could be
jeopardized; the manufacturer solely being
authorized to make any modification.
•
Do not leave a child unattended in the seat
or in the vehicle, at any time.
•
Never allow children to play with the car
seat.
•
Never install nor take out of the car this child
seat with your child in it.
•
This car seat must not be used without the
cover.
•
The seat cover should not be replaced with
any other than the one recommended by the
manufacturer, since the cover constitutes an
integral part of this restraint.
•
Do not allow your car seat to come into con-
tact with corrosive substances e.g. battery
acid, solvents etc.;
•
The buckle on the car seat is not fully tamper
proof; - you should dissuade your child from
playing with it.
•
Refrain from using it as a toy or as a seat
at home.
•
Never use this product if it has been in an
accident, or if it has become badly worn.
•
If your car seat has been involved in an ac-
cident at a collision speed above 10 km/h,
even though minor, you MUST dispose of it
and purchase a new one; even if your car
seat shows no signs of damage, there may
be weaknesses that you are unable to see;
if this car seat is involved in another accident
it may fail to protect your child.
•
For this reason we suggest that you NEVER
use or purchase a second hand car seat.
c) In the event of an emergency
•
In an emergency your child can be released
quickly by pressing the red button on the car
seat harness buckle (see fastening the har-
ness on Pic. 15).
d) Checking the vehicle seat belt
•
Installation of this child seat in the vehicle is
only suitable if the vehicle is equipped with
22
3-point seat belts with retractor, approved to
UN/ECE Regulation No.16 or other equiva-
lent standards.
•
The stability of the car seat can be affected
by the position of the vehicle seatbelt buc-
kle; if it happens to be positioned as in Pic.
2, this child seat is not suitable for use with
your belt or your vehicle
IV. Fitting Instructions
Warning:
Only use the car seat in the forward
facing position.
Use this child seat ONLY for secu-
ring your child in your vehicle.
This seat CANNOT be used against
the direction of travel.
Please always observe your country
regulations;
Should your vehicle be equipped
with front airbag, please observe
any instructions in the vehicle ow-
ner's manual
a) Installation of the child seat
1. Place the child seat on the appropriate ve-
hicle seat, facing forward (in the direction
of travel).
2. Make sure the backrests of the vehicle se-
ats are locked.
3. Ensure the vehicle seat backrest is in the
most upright and adjusted to the rearward
position.
4. Press the child seat firmly against the
vehicle seat and back of the vehicle seat
(fig 3).
5. Grip the reclining lever (Fig. 4) and pull the
seat forward until it's totally reclined (Fig.
5), to operate more easily.
6. Pull to open the locking lever of the red belt
clamp on the opposite side of the vehicle
seat buckle (Fig. 6);
7. Pull out the car safety seat belt and place
it between the backrest and the seat frame
(Fig. 7).
8. Slot the buckle tongue in the car seat buc-
kle (Fig. 8) until it clicks in;
9. Pass the lap section (Fig. 9) in the lower
red belt guides on both sides of the seat
frame.
10. Insert the diagonal seat belt section throu-
gh the red belt clamp (Fig. 10). Warning:
Ensure that the belt has not been
twisted (fig. 11);
11. Place your knee on the child seat to press it
into the vehicle seat.
12. Pull tightly upwards the diagonal section of