Drainage And Storage; Repair Kit - Waterflex Fit's Pool Guide D'installation & D'utilisation

8.3. Drainage and storage

Drainage
1
Check that the stopper on the bottom of the pool is well positioned.
2
Check that the drainage valve is closed.
3
Connect the drainage hose.
4
Remove the stopper on the bottom of the pool. open the drainage valve. Completely drain all water from
the spa pool. once empty, the pool can be cleaned with soap and water.
1
Storage
5
Press the bubbling button to blow out the water inside the jet holes. Unplug the pump.
6
Remove the filter cartridge, let the water flow out to dry the pump,as the picture below.
7
Use a towel to wipe off the pool, dry 24 hours. Fold the pool.
It is recommended that store the SPA in its original package in a warm dry place.
5

8.4. Repair kit

Little holes or puncture can be repaired with the repair kit included and glue reserved to pool liner.
1. Find the leak.
2. Thoroughly clean the area surrounding the leak.
3. Cut a piece of repair material in round shape, which should be larger than the damaged area.
4. Apply adhesive to the underneath side of the patch and around the area to be repaired.
5. Put the patch on the damaged area and press down firmly. Allow 12 hours for repair to dry. After patch has
dried, apply glue around the edges for a complete seal (dry 4 hours).
8. MAINTENANCE
2
6
3 4
7
45